No Shim and a Short - Transmission Digest

No Shim and a Short

Lorenzo Ortiz from Phillips Transmission had a 2005 Acura TSX with the MCTA five-speed transmission come into his shop for repairs. After it was repaired and installed into the vehicle, it had a new problem. The car would not start. The immobilizer lamp was flashing and the scan tool could not communicate with the engine control module, yet all other modules would communicate.

No Shim and a Short

Shift Pointers

Author: Wayne Colonna, Technical Editor
Subject Matter: 2005 Acura TSX
Issue: Speed sensor

Shift Pointers

  • Author: Wayne Colonna, Technical Editor
  • Subject Matter: 2005 Acura TSX
  • Issue: Speed sensor

When trying to start the car, the speed sensor was damaged

Lorenzo Ortiz from Phillips Transmission had a 2005 Acura TSX with the MCTA five-speed transmission come into his shop for repairs. After it was repaired and installed into the vehicle, it had a new problem. The car would not start. The immobilizer lamp was flashing and the scan tool could not communicate with the engine control module, yet all other modules would communicate.

Since this was not an original problem the transmission installation work was inspected. The ECM/PCM power and ground circuits checked good. But upon inspection of the two 5-volt supply speed sensor circuits, the 5-volt supply circuit for the countershaft speed sensor (yellow wire with a blue tracer) was found to be shorted to ground (see wiring diagram in Figure 1). The other 5-volt supply circuit checked good.

The actual cause occurred when the transmission was removed. The R&R technician did not disconnect the countershaft speed sensor; instead, it was removed from the transmission and left it connected to the vehicle wire harness. When the transmission was installed back into the vehicle, the R&R technician did not realize that there is a 0.080” thick spacer that goes between the speed sensor and the transmission case (Figure 2), so it was installed.

When an attempt was made to start the vehicle, the speed sensor was instantly damaged by the counter shaft gear (Figure 3). This damage shorted the 5-volt supply circuit for the countershaft speed sensor. It also caused the no-start condition and the loss of communication with the ECM. The immobilizer lamp was flashing because it could not communicate with the ECM. When the damaged speed sensor was disconnected, the engine started and ran, the immobilizer lamp stopped flashing and communication with the ECM returned.

Once a new speed sensor and 0.080” spacer was installed, all complaints were gone and the vehicle operated normally. As a side note, there were no communication codes set; however, there was a message in the multiplex module signaling a loss of communication with the ECM.

This incident serves as an example in some ways as to knowing that when a 5-volt sensor supply circuit is shorted, it negatively affects CANBUS communication.

You May Also Like

Sherlock Holmes Approach to an AB60 No-Move Situation

The effectiveness in diagnosing automatic transmission malfunctions is an art form. Although there are similarities among the wide varieties of transmissions on the road, each transmission has its own peculiarities. Aside from having mechanical, hydraulic, and electrical hardware systems to contend with, software/programming issues and various vehicle platforms make diagnostics much more difficult.  Using scopes provides

ab60

The effectiveness in diagnosing automatic transmission malfunctions is an art form. Although there are similarities among the wide varieties of transmissions on the road, each transmission has its own peculiarities. Aside from having mechanical, hydraulic, and electrical hardware systems to contend with, software/programming issues and various vehicle platforms make diagnostics much more difficult. 

GM 6T40 Pump Identification Guide

The 6T40 was introduced in 2008 for General Motors front-wheel-drive cars in the Chevrolet Malibu and has gone through several changes throughout its three generations, specifically in the pump area. The 6T40 is closely related to the more lightweight 6T30 and the heavier duty 6T45 and 6T50. Generation one started phasing out during the 2012

Seeing the Forest AND the Trees

They say that the proverbial phrase “I couldn’t see the forest for the trees” means that a person or organization cannot see the big picture because it focuses too much on the details. Related Articles – 4L60E Harsh 1-2 Shift – TASC Force Tips: Diagnosing 8L45 & 8L90 Shift Complaints – TASC Force Tips: Hydraulics

The Manifold Pipeway

The Honda six-speed transmission has been on the bench of many specialty shops for one reason or another (figure 1). But, for those of you who have yet to lay your hands on one, mounted on the upper side of the unit is one of the largest, if not the largest solenoid and pressure switch

8L90 Vacuum Testing

Below are the diagrams for vacuum testing GM 8L90 transmissions. Note: OE valves are shown in rest position and should be tested in rest position unless otherwise indicated. Test locations are pointed to with an arrow. Springs are not shown for visual clarity. A low vacuum reading indicates wear. For specific vacuum test information, refer

Other Posts

Shift of the shaft: Diagnosing Chrysler 48RE manual shaft issues

The TorqueFlite transmission has been around since mid-to-late 1950s. There have been many changes surrounding the manual shaft and rooster comb through the years. This transmission shaft controls the position of the manual valve that directs oil for the gear ranges, but it also is used for a Reverse light control as well as Park/Neutral

Shift Pointers: What to do when the 62TE TRS tab breaks

How frustrating it is when on a hot summer day, as you go to open a nice cold can of your drink of choice, and the tab breaks off? You are outside, away from any tools to remedy the problem quickly. It now requires a MacGyver mentality looking around at the resources available to get

Shift Pointers: Failures caused by incorrect tire sizes

For years ATSG has produced a wide range of issues related to improper tire sizes on vehicles. Even under-inflated tires have been known to cause issues. Problems such as premature failure with an active 4WD transfer case will occur with incorrect tire sizes. Related Articles – Diagnosing Ford 10R60, 10R80 and 10R140 series speed sensor issues

Shift-Pointers-Jan-Figure-1-1400
Shift Pointers: Focused DTCs

On occasions when a vehicle’s computer system detects an error, it can set an array of diagnostic trouble codes. The variety and quantity of them require the ability to diagnose diagnostic codes, so it’s nice when codes set that point directly to the problem.  Related Articles – Think pink: Curtis Price strikes out on his